Grasshopper

algorithmic modeling for Rhino

Tangent Plane

Hi,
I am new to GH, so this is a very simple question:
I am trying to create a surface which is tangent to a sphere on a given
point. I have succeeded in creating a plane like that, but when turning
the plane into a surface, it is automatically placed with its corner -
rather than center - coinciding with the point on the surface. Is there a smart way of changing that - or a better way of making tangent planes all together?

Thanks,
Anne


Views: 5011

Attachments:

Replies to This Discussion

Permalink Reply by David Stasiuk on November 12, 2010 at 11:52am
Use four "point oriented" components to create corners from the resulting plane, and then make a four point surface.

So, for example, if you want a square surface your point uvw coordinates would be:

2,2,0
2,-2,0
-2,-2,0
-2,2,0
Permalink Reply by Peter kluck on November 12, 2010 at 12:27pm

Attachments:
Permalink Reply by Chris Hanley on November 12, 2010 at 12:57pm
few ways to do it. Here is another example that takes a slightly different approach.


Rhino 4 SR8
GH Ver Version 0.8.0001
Attachments:
Permalink Reply by Anne Romme on November 13, 2010 at 3:15am
Thank you!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service