Grasshopper

algorithmic modeling for Rhino

tangent circles between 2 curves

Hi,

I might be asking for the impossible... but I'm looking for a definition to do the following.

- it starts with a circle that can be predefined; in this case, the largest green one on the left.

- from there, I want a circle that is tangent to the top curve, to the bottom curve and to a circle that is 2/3 (or some other factor, I imagine a slider here...) of the diameter of the first circle

- and so on, until the end of one of the black curves is reached...

I don't even know where to start with this - any ideas?

Thanks very much, Michiel

Views: 5632

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on February 2, 2012 at 3:53pm

A bit experimental but it could help:

Hoopsnake working step by step, couldnt find a good ending condition.

Attachments:
Permalink Reply by Nik Willmore on July 15, 2015 at 1:18am

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service