Grasshopper

algorithmic modeling for Rhino

Sweeps and duplicates

Hello, 

I've recently created a 3D voronoi but have run into a problem when I create edges using a brep component. the voronoi pattern is exactly what I need and I can succesfully sweep along the created lines to make them solid. 

However, when I did this I noticed that many of the lines created from the 3D voronoi appear to have duplicates. what is the best way to fix this? I have tried Kangaroo removeduplicatelines but it did not seem to work. 

Any help would be great.

Views: 244

Attachments:

Replies to This Discussion

Permalink Reply by Ryan Gathmann on March 19, 2013 at 9:15pm

So the trick to removing duplicate lines is to identify a common factor between them can can easily be compared. The best I have found is their midpoint. Give this file a try. Let me know if you have any questions.

Attachments:
Permalink Reply by Evan Hansel on March 19, 2013 at 9:23pm

This worked out great, thank you very much for the reply. I appreciate the help!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service