Grasshopper

algorithmic modeling for Rhino

Sweeping along a curve, with section curve oriented to Surface

Hi,

I am trying to sweep along these yellow curves, so that my extruded profile is oriented to this surface. I have been searching through the forums but struggling to see how their solutions work for me. Any help would be greatly appreciated. I am using a script, courtesy of Chris Tietjin and his post here:

http://www.grasshopper3d.com/forum/topics/sweep-many-rails-with-single

I found this very useful for an earlier piece I was working on.

Thanks

Phil


Views: 1740

Attachments:

Replies to This Discussion

Permalink Reply by Chris Tietjen on November 27, 2012 at 7:48pm

You might need to upgrade Grasshopper to 0.9.0014 to get a working sweep_1 component.

Attachments:
Permalink Reply by Philip Hurrell on November 28, 2012 at 2:39am

Thanks so much for that Chris. Its a great help! 

Phil

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service