Grasshopper

algorithmic modeling for Rhino

Sweep2

I am trying to make a structure for an egg like geometry.  I got curves that I want, but have problem when making surface.  I use SWEEP2 to make surfaces.  It work fine for vertical member, but not for the horizontal one.   Any suggestion?

Views: 735

Attachments:

Replies to This Discussion

Permalink Reply by Esben Clausen Nørgaard on January 5, 2012 at 4:44am

Maybe lofting the two curves instead?

Haven't tried, but i think the problem is that it is closed and therefore sweeping is a problem.

Permalink Reply by Noppon Pisutharnon on January 5, 2012 at 8:03pm

I did try Loft, but still can not solve the problem.

Permalink Reply by Kristjan on January 6, 2012 at 10:31am

Loft worked fine for me (see the picture).

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service