Grasshopper

algorithmic modeling for Rhino

Sweep2 problems in Grasshopper

Hi

I'm working with sweep2 rail component in grasshopper .

In rhino there is no problem and i can make a the surface without any problem but in grasshopper the sweep2 component does not work clearly , it makes a funny surface .

Is it a bug ?

Views: 256

Attachments:

Replies to This Discussion

Permalink Reply by Pieter Segeren on September 9, 2014 at 9:05am

After you rebuilt your curves, the connecting lines aren't connected to your rail curves anymore. I would just loft the two (rebuilt) rails curves in this case.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service