Grasshopper

algorithmic modeling for Rhino

sweep2 Error

Hello,

I realised, that depending on the order in which you add the section curves for the rail, it may have an effect on your sweep.

I just came to a point where i dont understand the behavior of one sweep in particular.

I enclosed my definition, in the hope that you guys may have the answer.

Thank you very much

Daniel

(the missing sweep)

Views: 322

Attachments:

Replies to This Discussion

Permalink Reply by Ethan Gross on June 6, 2016 at 9:44pm

Hi Dan, I assume you want a symmetrical figure, so flip both rail curves used in the irregular sweep.

Permalink Reply by daniel assayag on June 6, 2016 at 10:46pm

I thought of flipping it, but actually, i didnt want an exactly symetrical shape.

I still dont understand the problem, if it comes from my definition or from a bug

Permalink Reply by daniel assayag on June 7, 2016 at 1:49am

I found the solution

By Flattening all the rail and section curves i actually got the sweep to work!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service