Sweep does not work

Replies to This Discussion

Permalink Reply by TheChosenOne on April 13, 2011 at 10:12am

Try this...

Attachments:

• Sweep2rails closed curves.ghuser, 37 KB

Permalink Reply by Dedackelzucht on April 14, 2011 at 2:11am

I have only one rail and I do not want to split it, because I want to keep the miter joint

 

:-(

Permalink Reply by Pieter Segeren on April 14, 2011 at 3:56am

Hi Dedackelzucht, could you upload your definition (chengeaxis?), and indicate what you are attempting to do (maybe a 3dm). I'd be willing to give it a try.

Permalink Reply by Dedackelzucht on April 14, 2011 at 4:04am

its a definition by TheChosenOne

 

I just want to sweep a Profile around a rectengulars/planar/closed/curve

 

It works sometime, sometimes not. I do not understand why. How can the angle or the form of the rectengular/planar/closed/curve be the reason?

Attachments:

• ChengeAxis.ghuser, 37 KB
• FlipPlane.ghuser, 14 KB

Permalink Reply by Pieter Segeren on April 14, 2011 at 5:00am

I meant your definition, not just the component;) Save me some work...

Maybe a bit premature, but it might help to put your section curve right on the startpoint of your rail, if that isn't the case...

Permalink Reply by Dedackelzucht on April 15, 2011 at 12:51am

oh sorry... here you go!

 

section is rigth at the starting point. I checked that already (I read about that in older entries)

Attachments:

• 110413_Profile Sweep1_JB.ghx, 437 KB

Permalink Reply by Pieter Segeren on April 15, 2011 at 5:30am

NP:)

Hi Dedackelzucht, I got sth that works. You'll have to correct the deforming of the profile yourself (I scaled in 1 dir (I did this to avoid the offset), so the thinkness of the inside of the profile is scaled too), but I think you'll get the idea.

Attachments:

• 110413_ProfileSweep1_JB_PSG.ghx, 155 KB

Permalink Reply by Dedackelzucht on April 15, 2011 at 5:52am

haha, now its a mix! the 45º was a good idea! I had in mind, but i thought it would make it more complicated! That thought was wrong!

 

Thanks for helping! Always a pleasure!

 

DeDackel

Attachments:

• 110413_ProfileSweep1_JB_PSG_JB.ghx, 576 KB

Permalink Reply by Pieter Segeren on April 15, 2011 at 6:09am

gern gemacht:) Seems I misunderstood the reason for the offset. Good mix!

Permalink Reply by Dedackelzucht on April 15, 2011 at 6:13am

Goede hulp:)