Grasshopper

algorithmic modeling for Rhino

sweep along split curve

Hi all,

I'm covering a surface with rectangular profiles swept along rails. After that, I have found their intersections with vertical planes that are located on division points in a master curve. The distance between those points will determine the length of the profile.

Everything goes well until I sweep. It seems to be a problem of lists matching somewhere but I don't find it.

Thanks for your time in advance.

CEC

attached an image and .ghx

Views: 614

Attachments:

Replies to This Discussion

Permalink Reply by ng5 Alex on September 5, 2014 at 11:42am

Hello

since you have the sweep rails you can use only one of the section curves (they are same profiles right?)

cheers

alex

Permalink Reply by Carlos Espigares on September 8, 2014 at 2:48am

thanks Alex, was in front of my eyes.

Permalink Reply by Daniel González Abalde on September 5, 2014 at 12:04pm

The problem seems to be that the paths do not match.
You need to do a sweep? why not do a loft between profiles?

Attachments:
Permalink Reply by Carlos Espigares on September 8, 2014 at 2:59am

thanks Daniel. Loft is useful but sometimes the surface is not well attached to the edges and because of that I prefer to use sweep this time.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service