Grasshopper

algorithmic modeling for Rhino

sweep 2 rail problem

Hi all,

I’m quite new in using Grasshopper but I used the component sweep 2 rail in several different definitions with no problems,,, it worked until now as it does in rhino, but now I’m facing a problem with this and after fighting with it for days and cannot find the solution,,, it is driving me mad.

The thing is that the sweep surface is not correct, but when I make the same thing in rhino using the same curves the surface comes perfect,,,, as you can see in the rhino file.

I have attached the rhino file along with the gh.

All of this is a portion of a big definition, so I baked some curves to create this new one, and the problem remains exactly the same.

Pehaps is a very easy thing but as I said I have just a little experience in gh,,,,

Any help will be very welcome.

Thanks in advance,

Joan

Views: 989

Attachments:

Replies to This Discussion

Permalink Reply by Riccardo Majewski on February 29, 2016 at 5:42am

Hi Tomàs,

This is a common problem/mistake when using sweep function with grasshopper.

As rhino works, the sections start to sweep along the rail curve from the nearest point (from section to rail).

In grasshopper, instead, the section sweep along the rail curve from the seam point of the rail. (in case of closed curve rail)

I use the parameters you already extracted in your definition to adjust the seams of the rails, and flipped one of the two.

Take a look.

Cya :D

Attachments:
Permalink Reply by Joan Tomàs on February 29, 2016 at 8:00am

Hi Riccardo,

Fantastic, Thanks so much,,,, i would never come to know what was going on without your explanation.

thanks again,

Best ,

Joan

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service