Grasshopper

algorithmic modeling for Rhino

Sweep 1 Rail - Please Help

Hi !  
 I attached the ghx so you can see the problem. I can do it in rhino but grasshopper do not want to do it.  2 different radius circles (section curves) and 1 curve (rail) but the result (with sweep1) is no surface. Why is that ? What am i doing wrong ? Thanks for any replies !

Views: 1296

Attachments:

Replies to This Discussion

Permalink Reply by Boris Rüther on June 19, 2010 at 5:41am
hi i hope this will help you...
i think i didn't work because you need a vertical plane/frame on the base crv not just a point...

boris
Attachments:
Permalink Reply by Miklós Hatvani Deák on June 19, 2010 at 7:32am
Thanks a LOT !!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service