algorithmic modeling for Rhino
Sweep 1 Rail doesn't seem to be working...
I'm attempting to play around with the algorithm in IMAGE1, but although I believe I put in the algorithm correctly, Grasshopper seems to be getting stuck on Sweep 1 Rail as you can see in IMAGE2.
Due to my rather complex sweep1rail attempt not working, I tested the algorithm with the most simple sweep1rail I could think of (7 circles strong along a straight line) and the result was IMAGE3, which is the exact same result as the more complex models.
FYI: "Rail" is a Curve and "Sorting" is Merge, if that helps any.
Much appreciated, guys!
-C
Views: 519
- Attachments:
-
-
lavicka_nafb.jpg, 1.1 MB -
Screen Shot 2016-10-18 at 3.49.31 AM.png, 192 KB -
Screen Shot 2016-10-18 at 3.48.40 AM.png, 222 KB
-
Replies to This Discussion
-
Permalink Reply by Birk Binnard on
-
Here is a very simple alternative to Sweep1 that may or may not be useful for your purpose.
- Attachments:
-
-
bb.gh, 10 KB
-
-
-
Permalink Reply by Chris Beffa on
-
I'll give it a try, thanks!
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Field Contour
Added by Parametric House 0 Comments 0 Likes
-
Voronoi Facade
Added by Parametric House 0 Comments 0 Likes
-
Weave Mesh
Added by Parametric House 0 Comments 0 Likes
-
Pathway Frames
Added by Parametric House 0 Comments 0 Likes
-
Contour Chair
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
