Grasshopper

algorithmic modeling for Rhino

Surface trim issue

I'm trying to trim off circle openings in a surface extruded from a polyline. Doesn't matter which method I try I dont get it right. I tried extruding the circles through the surface and also projecting the circles on the surface. Any ideas? I'm running GH 0.9.0014

Views: 374

Replies to This Discussion

Permalink Reply by Joaquim Filipe Reis on September 25, 2013 at 5:30pm

Post the definition for we can help you . You can use intersection or split, but maybe it can be possible to obtain the same result with loft, I prefer loft because it is a faster process. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service