Grasshopper

algorithmic modeling for Rhino

Surface reparameterization

When I reparameterize a surface, the domain does not change to '0 to 1' as a curve does.  Is this operating correctly?  It seems like the domain should change if reparameterized.  am I missing something?

Thanks

Views: 1259

Replies to This Discussion

Permalink Reply by David Rutten on July 31, 2014 at 1:44pm

It should. Reparameterised surfaces should get a domain of 0.0 to 1.0 for both U and V domains.

Can you post a file where this doesn't work?

--

David Rutten

david@mcneel.com

Permalink Reply by Stan Carroll on August 1, 2014 at 2:43am

Yep it is working properly...I realized what I was doing wrong.  For a surface I was using the Domain component, in stead of using the Domain^2 component which works fine.  - Thank you David...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service