Surface points responsive to an attractor element (circle) through a path with Grasshopper.

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on August 29, 2016 at 3:37am

Looks like an application of basic multiful point attractor logic.

Check Attached, Yon can manipulate the ceiling by controling two "MD Sliders".

Attachments:

• Ceiling_re.gh, 14 KB

Permalink Reply by Allan Montalla on August 29, 2016 at 3:42am

Thank you very much! I will study on how the logic works! :)

Permalink Reply by Allan Montalla on September 17, 2016 at 12:12am

Hello sir, Is there a way to control or minimize the magnitude of attraction/repel to the lines?

I mean if i use one point and place it in the middle, it would create a half sphere effect on the lines in the middle. Thank you!

Permalink Reply by Hyungsoo Kim on September 17, 2016 at 3:39am

You mean something like this?

Permalink Reply by Allan Montalla on September 17, 2016 at 3:53am

yes sir!

Permalink Reply by Allan Montalla on September 17, 2016 at 3:54am

how is it possible to control the magnitude of attraction/repel? :D

Permalink Reply by Hyungsoo Kim on September 17, 2016 at 3:58am

Check this.

Attachments:

• Ceiling_reV2.gh, 13 KB

Permalink Reply by Allan Montalla on September 17, 2016 at 4:41am

Thank you!

Permalink Reply by Allan Montalla on September 17, 2016 at 10:55pm

Last question sir, is it possible to create 2 attractors that could create a different influence range control than the other? thanks!