surface patch - inflatable meshes with anchor points

Replies to This Discussion

Permalink Reply by ANGELOS on November 6, 2011 at 8:23am

I couldn´t achieve a solution yet,

except of interrupting the GH design at this point and continue with step by step solution.

If someone could anyway comment my question at least.

---Is the answer to obvious (and easy to handle - I cannot find it however).

---Is a solution only achievable with scripting (?)

---Is it a matter of how the GH works, so the solution I´m expecting is not achievable.

 

Thanks for any comment,

angelos

 

Permalink Reply by Jon Mirtschin on November 6, 2011 at 9:39am

Hi Angelos,

 

I can't really comment on Kangaroo, maybe someone else with more knowledge of it can help there.

 

I can say I try to make the StructDrawRhino options for these types of tasks as easy to use as I can.  I've attached an image and result for you to see if this is your intended result.

 

Cheers,

 

Jon

Attachments:

• CUSHION_MAP_01 sdr.gh, 17 KB

Permalink Reply by ANGELOS on November 6, 2011 at 9:50am

thanks Jon,

at least I see it working,

this Inflate mesh component that you are using, is it implemented in one of your plugins?

Angelos

Permalink Reply by Jon Mirtschin on November 6, 2011 at 10:04am

Yes,  I have an inflate component as part of the computational geometry tools in StructDrawRhino plugin.  http://www.geometrygym.com/downloads  My tools certainly aren't capable of generating as advanced options or forms as Kangaroo, but the trade off is I think they are simpler to use.

 

Cheers,

 

Jon

Permalink Reply by ANGELOS on November 6, 2011 at 10:12am

I see,

 

so it could be seen as further help, getting a quick overall-picture, and then switch to e.g. membrane-software, one step earlier.

 

thanks again for your reply,

angelos