Surface from two curves point

Replies to This Discussion

Permalink Reply by lucas cañada on April 4, 2012 at 5:13pm

Ciao Jacopo! here i can help you. Your input ellipses are not in same direction, i´ve flipped one and used shatter component. Hope helps.

Attachments:

• curve_point1.gh, 4 KB

Permalink Reply by Jacopo Baldini on April 5, 2012 at 2:31am

Thanks Lucas....It's great...Anyway I'm using this definition for making trasversal cuts on my Tower...(you can see the image)...Actually I don't undestand how works the Shutter component...I need to improve the segment division but I don't undestand how...cheers

Attachments:

• jacko_tower1.gh, 38 KB

Permalink Reply by lucas cañada on April 9, 2012 at 5:22pm

Im sorry for delay but ive been on hollidays!

Cheers ;)

Attachments:

• jacko_tower_2.gh, 38 KB