"Surface from point" using Attractor and Graph Mapper.

Replies to This Discussion

Permalink Reply by David Rutten on September 10, 2013 at 2:46am

Hi Shridhar,

It seems it bulges in the middle more than near the ends. So it's not just elevation based on closest distance to curve attractor. There's at least one other effect going on here. Perhaps the elevation is also affected by the parameter of the curve closest point, or perhaps the distance from the curve mid-point. Or maybe the curve has been divided into a large number of points and all of these points together form the new attractor.

I'm not sure but you'll have to decide which approach you want.

--

David Rutten

david@mcneel.com

Tirol, Austria

Permalink Reply by David Rutten on September 10, 2013 at 2:57am

Here the distance effect is multiplied by another Graph Mapper that amplifies the effect based on curve parameter.

--

David Rutten

david@mcneel.com

Tirol, Austria

Attachments:

• DOUBT.gh, 7 KB

Permalink Reply by Shridhar Mamidalaa on September 10, 2013 at 5:58am

Thank a lot :D