Surface From Non Planar Curve

Hi everyone. Probably this question will sound quite dull but is there a way of creating a surface (to be further transformed into a mesh) from a non planar periodic curve?

Attachments:

Picture 2.jpg, 338 KB

Replies to This Discussion

Permalink Reply by Giulio Piacentino on May 7, 2012 at 6:37am

Hi Fabio,

I'm not aware of a general method for that, but if the curve is a polyline, you could use the Rhino _MeshPolyline command to directly obtain a mesh.

I hope this helps,
- Giulio
_______________
giulio@mcneel.com

Permalink Reply by Fabio on May 7, 2012 at 6:47am

Hi Giulio. Thanks for your reply.

I managed to get the same results applying the divide curve and Delaunay mesh command. I don't know if that is the right path to go but it works for now.

Permalink Reply by Giulio Piacentino on May 7, 2012 at 7:51am

Sounds good: as long as there is a plane for Delauney, this method should work.

- Giulio
_______________
giulio@mcneel.com

RSS