algorithmic modeling for Rhino
do you mean loft?
The definition of GH lacks finish straight ends. ..
In short. I try to create a surface that contains at 6 curves. In rhino this is done by the functioncurve network which is not the same loft. .
Take a look at http://www.grasshopper3d.com/xn/detail/2985220:Comment:10869
You will have to sort your curves the same way.
Ok I see and I mention as a result!
Works great but I need to be modified to engineer the surface. Good job! I would like to know VB
Here is your modified GH file in case you didnt manage to use the script.
(Works under rhino4)
Network Surface are only available in Rhino5 SDK, so if you're running inside Rhino5 then you can create a VB/C# component but there's no native component that does this.
--
David Rutten
david@mcneel.com
Poprad, Slovakia
ok thanks david!
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by