surface from curve network

Replies to This Discussion

Permalink Reply by Michael Pryor on January 25, 2012 at 7:53pm

do you mean loft?

Permalink Reply by fernando molas garcia on January 25, 2012 at 8:26pm

Michael

I show you my definition. and what I want to go.

the surface shown in rhino get it from the network of curves that are there.

Attachments:

• repisa.3dm, 213 KB
• repisa.gh, 13 KB

Permalink Reply by fernando molas garcia on January 25, 2012 at 8:28pm

The definition of GH lacks finish straight ends. ..

Permalink Reply by fernando molas garcia on January 25, 2012 at 8:31pm

In short. I try to create a surface that contains at 6 curves. In rhino this is done by the functioncurve network which is not the same loft. .

Permalink Reply by Yoann Mescam (Systemiq) on January 26, 2012 at 2:17am

Take a look at http://www.grasshopper3d.com/xn/detail/2985220:Comment:10869

You will have to sort your curves the same way.

Permalink Reply by fernando molas garcia on January 26, 2012 at 5:23am

Ok I see and I mention as a result!

Permalink Reply by fernando molas garcia on January 26, 2012 at 6:03am

Works great but I need to be modified to engineer the surface. Good job! I would like to know VB

Permalink Reply by Yoann Mescam (Systemiq) on January 26, 2012 at 12:29pm

Here is your modified GH file in case you didnt manage to use the script.

(Works under rhino4)

Attachments:

• repisa.gh, 17 KB

Permalink Reply by David Rutten on January 26, 2012 at 11:00am

Network Surface are only available in Rhino5 SDK, so if you're running inside Rhino5 then you can create a VB/C# component but there's no native component that does this.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by fernando molas garcia on January 26, 2012 at 11:03am

ok thanks david!