Surface Fitter

Replies to This Discussion

Permalink Reply by David Rutten on March 15, 2011 at 9:56am

Hi Dackel,

 

that particular algorithm works by adjusting control-points. If you start doing that on a Brep (Brep = PolySurface), then you'll rip apart adjacent faces. There's no mechanism in Rhino or our SDK that would allow you to change the control-points of one face while adjusting adjacent faces to maintain closed edges.

 

Are you looking to adjust a brep so that it matches a set of points? Would something akin to a spatial deform be helpful?

 

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Attachments:

• SpatialDeform.ghx, 59 KB

Permalink Reply by Dedackelzucht on March 16, 2011 at 2:12am

Hey David,

I tried this one before, but the result is not smooth enough. I posted a  new add in the grasshopper discussion area.

 

thank you

 

Dackel