algorithmic modeling for Rhino
Surface divide angle and adjust point
Hello.
Sorry to brief question.
I have the following two questions.
question1：surface divide 0°→45°
I want to execute the above.
question2：Start point and end point do not match
I want to adjust points.
Excuse me, but could anyone tell me?
Views: 515
- Attachments:
-
-
question1(surface divide 0°→45°).png, 356 KB -
question2(Adjust end points).png, 569 KB
-
question file(3dm、gh).zip, 43 KB
-
Replies to This Discussion
-
Permalink Reply by Hyungsoo Kim on
-
Hi.
Check attached. Best.(Note; You can also use "Lunchbox" plug-in)
- Attachments:
-
-
Permalink Reply by Hiroaki Takahashi on
-
Thank you. I appreciate it very much!
As you have taught me, I will also try Lunchbox (^^).
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Voronoi Wall
Added by Parametric House 0 Comments 0 Likes
-
Kangaroo Column
Added by Parametric House 0 Comments 0 Likes
© 2025 Created by Scott Davidson.
Powered by
