Grasshopper

algorithmic modeling for Rhino

surface box height control

Hi,

i'm trying to morph geometry within a bounding box to surface boxes which i've created over a surface.  what i want to do is have a variable height for the surface boxes, based on the distance between an independent point i've set, and each of the points on the divided surface.  what happens is that the geometry i'm trying to morph gets applied to each surface box many times, to each of the heights corresponding to the distances between the point and the divided surface points. 

so, the question is, is it possble to set variable surface box heights based on some algorithmic input, or am i stuck with a single input for the heights across the whole surface?

thanks!

Views: 1946

Replies to This Discussion

Permalink Reply by djordje on May 24, 2013 at 3:28pm

Hi Grant,

Yes it is possible. It's a data matching issue.
Check the following definition:

Attachments:
Permalink Reply by grant scott on May 24, 2013 at 4:08pm

well above my pay grade, so thanks a ton. 

this should be useful for me to work through how it all works.  i appreciate your time.

g

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service