Grasshopper

algorithmic modeling for Rhino

surface boolean

hello guys,

I just have a simple question, I am having some difficulties booleaning two overlapping surfaces. i just cant find the command for it.

i would really appreciate it if you could help me with this.

thanks a lot.

Omid

Views: 4348

Attachments:

Replies to This Discussion

Permalink Reply by taz on October 13, 2010 at 7:43pm
Extrude the middle surface in two directions and cap it. Then use trim solid.

Permalink Reply by Omid MK on October 13, 2010 at 8:02pm
thanks taz, it really helps
Permalink Reply by Peter kluck on October 14, 2010 at 12:27am
try this new component too (Intersect-->Physical-->Surface Split):

http://web.me.com/rhino3dtv/TV/Tutorials/Entries/2010/9/21_2010_09_...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service