Supports moving when running Karamba with Kangaroo

Replies to This Discussion

Permalink Reply by Robert Vier on July 11, 2012 at 9:58am

this most probably is caused and solved by the following:

for defining the actual points to put into the 'supports' component, use 'fsim' with input 'D' as your points and 'S' as the points that come out from the 'line to beam' component. 

this makes sure the point indexing is the very same. this is caused by the logic 'line to beam' works, where duplicate points and lines are removed and therefore the list length changes.

hope this helps

best

Permalink Reply by Arthur Mamou-Mani on July 11, 2012 at 11:32am

Thanks a lot Robert, it is fixed and I have replaced the video.