Subtract a surface from another surface

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on May 21, 2015 at 12:27am

Hi.

This def. will let you choose attractor & repulser mode and have a subtracted surface.

Attachments:

• UTDscrim_re.gh, 19 KB

Permalink Reply by Helena Zambrano on May 21, 2015 at 2:08pm

Hi Hyungsoo,

That work perfectly! Thanks a lot! If I can ask another question..
I'm attempting to rotate the circles in the X and Z axis. Each one being rotated individually from their own center (like in the sketch), and the angle of rotation being influenced by the attractor line. So far I can only make them rotate all together from either a common reference point or from the attractor line (like in the picture below).

Peter, thanks for your help too, I think yours is too advance for me.

I re-attached the definition, any help would be very much appreciated.

 

Attachments:

• UTDscrim2.gh, 14 KB

Permalink Reply by Kim hauer on May 22, 2015 at 10:31am

Oops!

Permalink Reply by Kim hauer on May 22, 2015 at 10:32am

Hi Kim
I always look forward to your solutions and problem solving techniques. :)
This particular script runs very very slow on my computer, regardless of which slider I change.

I made a few revisions (see attached gh) , thinking I would gain some time NOT looking at a blank screen while grasshopper was calculating. Turns out not to have made a difference. Still takes 184sec to recalculate on my computer.

1. I was wondering if you know what in the script is the main cause of the recalculating time issue?

2. Is there a way attractors can be used without having to be internalized in the script?
I would just like to move the points on the fly, or better yet simple draw a polyline curve over the SQgrid.

Attachments:

• UTDscrim_re1.gh, 21 KB

Permalink Reply by Hyungsoo Kim on May 23, 2015 at 12:27am

Hi.

If you can match the number of grid cells and polygons, there' might be no time consuming.

If you want to merge all faces or split, cut out holes, you cannot help avoiding calculation  time. 

If you want to manipulate your curve attractor more easily, just draw a curve in rhino and reference it into GH. and replace interpolate curve component.

Attachments:

• UTDscrim_re2.gh, 17 KB

Permalink Reply by peter fotiadis on May 21, 2015 at 1:34am

In addition to Kim's stuff get this as well (it is controlled by the 3 filters/gates [yellow groups] and operates on grids and surfaces). Any number of attractor pts in push/pull mode etc etc.

Works with code (advisable, especially with many attractors) and/or components. 

When in Grid mode this group ...

...makes what you want (deactivated as delivered: VERY SLOW, can't keep up live with the rest of the def).

Obviously with a few changes it could work by "perforating" attractor "influenced" holes in any surface as well (notify if you want such a capability, including holes made out of curves instead of circles).

Attachments:

• attractors_v1.3dm, 304 KB
• attractors_v1.gh, 66 KB