Grasshopper

algorithmic modeling for Rhino

subdividing flat trimmed surface

Hi,

is there a way to subdivide (U/V) a simple flat trimmed surface into many subsurfaces?

right now the subsurface (isotrim) component always considers the untrimmed surface rather than the trimmed one...

rebuilding or shrinking does not help.

any ideas?

thanks,

Peter

Views: 830

Replies to This Discussion

Permalink Reply by Robert Harvey on July 19, 2011 at 7:07am
Have you tried "Brep Components" and recreating the surface with the resulting edge curves using "Edge Surface"?
Permalink Reply by peter on July 20, 2011 at 2:17pm

thanks...

don't think that would work with more than 4 edges though ....

I'll keep trying

regards,

Peter

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service