Grasshopper

algorithmic modeling for Rhino

subdivide surface to follow edges

Would it be possible to subdivide a surface to follow the edges? So that the lines would bend and the corners.  So far I have not been able to get an accurate

I've only been able to get this

I've attached the file as well.

Views: 791

Attachments:

Replies to This Discussion

Permalink Reply by Liam Morrow on April 3, 2012 at 8:39am

the two curves are the edges of the surface

Permalink Reply by Hannes Löschke on April 3, 2012 at 9:31am

I you create the surface as a loft or rail between the edge lines, you can extract the blend results with the IsoCurve component.

Permalink Reply by Liam Morrow on April 3, 2012 at 10:39am

what do i add to get the uvs for the isocurve

Permalink Reply by Liam Morrow on April 3, 2012 at 10:47am

thanks got it

Permalink Reply by Erick Vásquez on April 3, 2012 at 10:03am

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service