Grasshopper

algorithmic modeling for Rhino

Stress analysis on mesh - KARAMBA

Hi

I just started using karamba for stress analysis, but I havent been able to get it on a surface of a mesh,  to localize areas under compression and tension. Im testing it in a dome, but just got the lattice analysis, which is nice, but I need the mesh analysis. Find the image attached.

 

Possible? Any suggestions?

 

Thanks!

Views: 14325

Attachments:

Replies to This Discussion

Permalink Reply by Karamba3D on May 19, 2014 at 11:29am

Try the divide and conquer strategy: When you have a definition that does not work as expected reduce the complexity of the definition and divide it until it works.

This helps you locate the problem: the bug must be somewhere in between the definition that works and that which does not work. Now divide again until you find the problem.

Best,

Clemens

Permalink Reply by Chi-X on May 20, 2014 at 5:37am

Thank you

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service