Grasshopper

algorithmic modeling for Rhino

strange behaviour of extrusion in bowerbird

Hi,

Untill recently I had no problem with extruding the specially designed bowerbird font but all of a sudden I encounter all kinds of problems. Especially with lower case a and both capital S and small s.

The curves seem alright but when I extrude (in Grasshopper) it doesn't look good.

See pictures.

Can you hgelp me with this?

Thank you,

Michiel van der Kley

Views: 354

Attachments:

Replies to This Discussion

Permalink Reply by Thomas on July 31, 2014 at 11:06am

Hi Michiel!

Sorry, but I haven't seen this thread before. If you post questions about Bowerbird in the group forum I will get a notification.

I tried to extrude bold letters and it worked without problems. It only takes some time to extrude the 'S'. I have to optimize the letter definitions to speed this up. The extrusion works anyway. Maybe this was a problem with an older version of the plugin.

If you still have this problem please post the Grasshopper definition so i can take a look at it.

Cheers!

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service