Step Size of an MD Slider

Replies to This Discussion

Permalink Reply by Hannes Löschke on February 25, 2014 at 2:10am

Double click the MD-Slider canvas to bring up the options for the numerical domain.

Permalink Reply by Hannes Löschke on February 25, 2014 at 2:45am

I wasn't sure if the MD slider would behave like a normal slider where the given precision of the domain determines the output resolution.

Explode the point components and feed them through an "int" param. then recombine the coordinates again. That'll round your output to integer steps.

Permalink Reply by Danny Boyes on February 25, 2014 at 2:48am

You could do this with rounding the x and y components of the slider:

 

Permalink Reply by Filippo on September 17, 2015 at 3:39pm

Hi

I am trying to generate a set of N  set of x,y coordinates interpolated by the bezier crvgiven by  a MD slider

so far I am not able to generate any set of values..would you please help me to undestand if there is something wrong on what i am doing or if i need to set up my definition/components differently

I get a single set of XY coord. ( Dom 0.1/0.1 )  when the slider is setted as default but when i switch it to bezier crv nothing is generated

I think this has something to do with domain a series , i tried to split the "d domain trough a Div Dom comp but the point is that there is nothing coming out of the MD slider

is it possible to make what i want , does anyone can help me 

thanks in advance, regards

Filippo