Spliting and deleting duplicated curves - voronoi exoskeleton

Hi,

I am beginner in GH.

I have some problems with duplicated curves that i get from some of voronoi definition from the forum (it didn't make me any mesh and it made duplicate curves) - vornoi on mesh definition).

I was reading all of the post and i tried to make some definition for duplicated curves.... but it doesn't work :(

After that i want to make exoskeleton from curves (before that i made some voronoi curves on brep) . I want to use it for making on different breps vornoi patterns - i didn't find any working definition on teh forum. If You have some working one please share or let me know how to do this :)

Do You have any solution for my problem ?

Cheers

Attachments:

spliting and deleting duplicated curves.3dm, 4.6 MB
spliting and deleting duplicated curves.gh, 13 KB
voronoimesh.gh, 26 KB

Replies to This Discussion

Permalink Reply by Laurent DELRIEU on August 7, 2016 at 2:59pm

You could "explode" your polylines and then use cull duplicate. Don't forget to flatten the input of cull duplicate.

Did you test Cocoon ?

Permalink Reply by Marcin Nowak on August 8, 2016 at 12:36pm

Thx Laurent i will try it.

I didn't test Cocoon yet... I will dowload it and try :)

Permalink Reply by Laurent DELRIEU on August 8, 2016 at 1:36pm

I meant remove Duplicate Lines not Cull Duplicates !

Permalink Reply by Marcin Nowak on August 8, 2016 at 2:22pm

I don't see any Duplicate Lines component.. where can i find it?

Is it from Kangaroo?

Permalink Reply by Laurent DELRIEU on August 8, 2016 at 2:58pm

The one in red you use, yes from Kangaroo

Remove DuplicateLines

Permalink Reply by Marcin Nowak on August 8, 2016 at 3:39pm

I did it but it killed my computer hehe :( I think that there a bug in the definition

Permalink Reply by Laurent DELRIEU on August 8, 2016 at 10:10pm

Perphas it is because it is curves you can transform them in lines using begin and end points.
You can cull duplicates curves using their center. You take the point on curve component then you use cull duplicates points with the good option, not average. You use the list of culled points to dispatch your curves and this could do the joB
PS I have not my PC now so I am not 100% sure of the names.

Permalink Reply by Joseph Oster on August 7, 2016 at 3:15pm