Grasshopper

algorithmic modeling for Rhino

split surface problem

Hi everyone,  I am trying to split a surface with a bunch of curves. What I need is to select the inner surface surrounded by these curves. I can't figure out what is going wrong. The surface does not split with all the curves. Any help appreciated

Views: 1205

Attachments:

Replies to This Discussion

0ddw589ypu3jvPermalink Reply by 0ddw589ypu3jv on July 31, 2017 at 5:32am

See attached and you can find the difference!

Attachments:
Permalink Reply by iro skouloudi on July 31, 2017 at 5:39am

thank you panda!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service