Grasshopper

algorithmic modeling for Rhino

Split different surfaces into subsurfaces with equal dimensions.

I am building cover for the metro entrance and I'm stuck in one moment.

I want to divide each wall of the cover into segments with equal width.

Side walls and roof were divided and I want to divide the back wall into subsurfaces with equal width. It would be also great if the panels would be measured starting from back wall's center vertical axis.

Views: 1754

Replies to This Discussion

Permalink Reply by Chris Tietjen on June 19, 2011 at 6:21pm

It was faster for me to create my own definition, but maybe this will give you some ideas.  If your panels are all going to be the same width then you have to accommodate for this in the sizing of the base.  This definition only gets them pretty close between the side and back walls...perhaps though visually sufficient.

 

Chris

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service