Grasshopper

algorithmic modeling for Rhino

Split and extrude surfaces

Hi

I'm trying to split a surface with some curves and then extrude the regions inside

I included a file with the desired model to explain better

In the .gh file I tried to extrude the planar surfaces and then split with the surface, but the process involving more regions become a slow process file

Thanks for your help

Views: 457

Attachments:

Replies to This Discussion

Permalink Reply by Jissi Choi on August 13, 2012 at 1:50am

I think there is a subtle marginal problem when making planar surfaces..

Check the attached file..

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service