Grasshopper

algorithmic modeling for Rhino

Spiral Paths

Hey guys, 

I would like to model spiral ramps similar to the ones in the attached picture. 

I already figured out how to design the spirals in 2D in Grasshopper. The next step is to move the curve control points in Z-direction, but every start and end point should stay on the ground. I already tried to get it with kangaroo (springs + unary force) but didn't get a satisfying result. 

Thanks a lot. 

Views: 418

Attachments:

Replies to This Discussion

Permalink Reply by Mohamed Naeim on December 9, 2016 at 4:18am

Like this? 

Attachments:
Permalink Reply by Philipp S on December 10, 2016 at 5:06am

That helps a lot. Thank you very much!!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service