Grasshopper

algorithmic modeling for Rhino

Spatial Deformation Problem

Hello,

i want to deform (countless) surfaces through their (middle) surface points and along their normal vector (see example below) but i have no idea how to set up my grasshopper definition. :(

Any tips?

Thanks! 

Views: 450

Attachments:

Replies to This Discussion

Permalink Reply by David Rutten on June 25, 2014 at 12:44pm

Moved from FAQ into Discussion forum.

--

David Rutten

david@mcneel.com

Permalink Reply by Damon on June 26, 2014 at 9:29am

Here's the start of something. Not much, but something...

It takes the points on the surface and moves them randomly away from the surface, so you'd have to change that part to only move the points you want to move. If your surfaces already have the correct number of control points, then you could use the Surface Points component instead of Divide Surface.

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service