Grasshopper

algorithmic modeling for Rhino

sorting points into workable groupings

I'm trying to arrange a set of points from a divided surface into workable sets.  My first thought is to take the area of a subsrf and then find the points with the same Z coordinates, and/or X, or Y, trying to create a set of points from a larger group.

 

Please see picture attached - Is this possible?

 

thanks - RF

Views: 554

Attachments:

Replies to This Discussion

Permalink Reply by Hannes Löschke on February 12, 2013 at 12:37pm

check the attached file

Attachments:
Permalink Reply by Ryan Freeland on February 12, 2013 at 1:16pm

thanks - i am trying to use the area centroids of surfaces from an isotrim instead of just dividing the surface. Any thoughts?

My end goal is to be able to manipulate each of these points and move them to measure the distance between the original centroid and moving it to then find the length between to then extrude the surface to create more of an undulating brick surface.

Thanks - RF

Permalink Reply by Chris Tietjen on February 12, 2013 at 3:08pm

Is this the effect you're trying to achieve?  If not how does it differ?

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service