Grasshopper

algorithmic modeling for Rhino

Sorry for easy question about surface.

I tried to make surface from data but it doesn't go what I think.

here it is 

left one is almost, but surfaces near corner and its opposite corner is missed.

and right one is made in the same way as left though, it's messed.

plz somebody tell me why. I attached this file below. Thank you

Views: 327

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 16, 2016 at 3:53am

So, somebody in this forum who is willing to help you must read the data from your computer?

Permalink Reply by Y_u on September 16, 2016 at 7:04am

Oh sorry, I forgot that. In new attached file, the each file (node, element, displacement, area) is copied to panel. Thank you for noticing me.

Attachments:
Permalink Reply by Hyungsoo Kim on September 16, 2016 at 8:23am

It looks like some sort of quad-mesh data to me.

In my opinion, you don't have to use "Surface from Points". Try "4pointSurface" instead.

And another option is generating meshs and Join & weld+thicken mesh and finally convert to poly-surface.

Check attached. You'll need "Weaverbird" plug-in. Best.

Attachments:
Permalink Reply by Y_u on September 19, 2016 at 5:35am

Thx, I did it!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service