Solid Intersection issue

Replies to This Discussion

Permalink Reply by nikos tzar on February 1, 2015 at 2:58pm

Hi robinzon,

I believe you just need to close (cap) your breps before intersecting them:

Permalink Reply by robinzon on February 1, 2015 at 3:11pm

Thank you so much!!!

Permalink Reply by robinzon on February 2, 2015 at 7:01am

Hi Again,

One another issue is that I need to move the intersection result's to the points on the circle (see the attached screenshot).

I tried to use MOVE TO PLANE and other stuff with points and it didn't worked for me.

I can move those elements only by use the MOVE component with a vector 'simple' vector.

Is there a way to move each one of the intersected elements onto the circle (aligned to the closets points)?

Thank you very much!!!

Attachments:

• Screen Shot 2015-02-02 at 3.57.59 PM.png, 70 KB
• move intersection elements.3dm, 361 KB
• curves 1.2.gh, 14 KB

Permalink Reply by nikos tzar on February 2, 2015 at 8:48am

You can use [orient] for that so that you move & rotate at the same time:

ps. please note that your first and last sections have half width from the rest (half of the wood plate is outside the brep)

Attachments:

• curves1.2-nt.gh, 11 KB

Permalink Reply by robinzon on February 2, 2015 at 8:58am

WOW...

Thank you so much, I really appreciate that.