Grasshopper

algorithmic modeling for Rhino

Solid Difference Multiple Breps

Hi everyone,

I have some problems trying to solid difference a brep with multiple breps. When I try to solid difference the breps, the solid difference component only subtract the on one surface but not the other. As shown in the image below the back side of the brep can be subtracted but not the front one.

Do any of you have a suggestion for this? Thank you in advance for your help. I would appreciate it very much.

Views: 1346

Attachments:

Replies to This Discussion

Permalink Reply by Joseph Oster on November 10, 2017 at 6:24pm

You don't really have a solid so I used 'SrfSplit' instead to cut the holes in two of the surfaces.

Attachments:
Permalink Reply by Xavier on November 11, 2017 at 3:43am

Hi Joseph,

Thank you very much for your help. It's very helpful.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service