solid difference fails while it should work just fine.

As you can see the trim does not work.
three lofts all joint into a solid and cut
with a solid / curve just hides actually
the shell top and bottom surface
only the sides remain, or are hidden if
I trim both sides as well.

what is wrong here?

Attachments:

Seat Shell Offset BeRep Loft.3dm, 33 KB
Seat Shell Offset BeRep Loft.ghx, 134 KB

Replies to This Discussion

Permalink Reply by Matt Gaydon on February 2, 2010 at 1:33am

HI Claas

Flatten the input going into the Brep Join component as at present it outputting the 6 input surfaces again and not a closed Brep.

You will also want to increase the vector lenght in the extrude component as at present it is to short to boolean all of the edges of so you solid difference output is giving you 3 surfaces and not just the middle 1. Best way to do this is just click on D of the extrude then manage vector lenght and increase the number to 4 say (thats what i did)

hope this helps

matt

RSS