Grasshopper

algorithmic modeling for Rhino

Slope analysis help?

Hi,

I've found a very handy script for topography analysis, but I fail to extract and use the analysed surface edge points together with their slope value (in deg).
Apart from the display of the colour values, I'd like to use the analysed slopes for the placement of bigger or smaller geometries, depending on their steepness.

Can anybody please point me into the right direction?

Views: 1950

Attachments:

Replies to This Discussion

Permalink Reply by Nader Belal on October 28, 2014 at 7:00am

Did you get an answer for that ?

Permalink Reply by Mikhail Borushko on May 1, 2017 at 5:10pm

I'm sure that it's no longer relevant three years later but for those who are still trying to do it: just use "-ViewCaptureToFile" command in Rhino (pay attention to "-" character) and set any resolution you want.

Permalink Reply by mark zirinsky on May 1, 2017 at 6:06pm

thanks I did not know about that one

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service