how to simplifying mesh faces ??

Replies to This Discussion

Permalink Reply by ZAQI FATHIS on September 17, 2014 at 10:48am

anyone help ?? 

Permalink Reply by Hyungsoo Kim on September 18, 2014 at 4:33am

Hi!  zaqifathis.

You'd better predivide your initial poly-surf. like my digram posted with.(A to B)

To do that, you should explode your poly-surf. and sub-divide each face at every intersections of faces.(using split face by isocurve command)

and then rejoin and finally feed to GH def.(Brep container)

If you really want to make equally divided mesh faces, then you'd better use same module grid to generate your polysurf.

see my attached images. Hope this helps you a little.

Permalink Reply by ZAQI FATHIS on September 18, 2014 at 10:38am

Hi Hyungsoo Kim,

you mean that after I explode my poly-surf, i must sub-divide in rhino? or could I do it in GH?

but by the way, thank's for your advice. :)

zaqifathis.

Permalink Reply by Hyungsoo Kim on September 18, 2014 at 2:04pm

Of course you can do it in rhino, but if you are really lazy enough to do this in GH, you can add the upper part of my def. like my image post with.

Have another try! Hope this works out for you.

Permalink Reply by ZAQI FATHIS on September 18, 2014 at 8:14pm

thank you so much Hyungsoo Kim :D