simplify grasshopper script

Replies to This Discussion

Permalink Reply by David Rutten on October 9, 2016 at 11:14am

Since that file uses two types of component I don't have, any chance of you explaining the logic of a single panel?

Permalink Reply by Saurabh Singla on October 9, 2016 at 11:17am

I want each panel to rotate separately.

Permalink Reply by David Rutten on October 9, 2016 at 11:34am

So each panel is a section of the major surface, using IsoTrim, and you want to rotate each one around the axis that connects the top two points of each quad?

How about the direction of the UV curves? They don't seem to match your panelling direction. And what about the trimming of the surface? Do you want to limit the panels to the inside of the surface only?

Permalink Reply by Saurabh Singla on October 9, 2016 at 11:36am

Yes! each panel is a section of the major surface. 

I want to rotate the panels around the upper axis of each panel.

Permalink Reply by David Rutten on October 9, 2016 at 11:46am

Attachments:

• rotatepanels.gh, 53 KB

Permalink Reply by Saurabh Singla on October 9, 2016 at 11:52am

Perfect! Its working,Thanks a lot

Permalink Reply by Mariah Zuzuvecha on October 9, 2016 at 11:51am

Since 2 months I tried a script on grasshopper . I need help too

best regards

Mariah.

Permalink Reply by Hyungsoo Kim on October 9, 2016 at 12:04pm

Hi.

Sounds like not a good idea ,anyway,

if you really want individual control of each panel, then try "Gene pool".

Gene pool is a kind of bundle of number sliders.

Permalink Reply by Saurabh Singla on October 9, 2016 at 12:43pm

Could you send me the script please?

Permalink Reply by Hyungsoo Kim on October 9, 2016 at 12:45pm

Here it is.

Attachments:

• IndividualPanelRotation.gh, 23 KB