Simple Sweep2Rail

Replies to This Discussion

Permalink Reply by Gennifer E Munoz on July 16, 2009 at 8:28am

As far as I can tell from rebuilding the definition you have, the direction of the rail curves and the order you choose the section curves must be the same. Hope this helps.
GM

Permalink Reply by Arthur Mamou-Mani on July 16, 2009 at 8:42am

Thanks a lot gennifer that was the solution:)

Permalink Reply by Arthur Mamou-Mani on July 20, 2009 at 9:39am

Hi gennifer,
Is it possible to visualize directions of curves ?
thanks,
Arthur

Permalink Reply by Dirk Anderson on July 20, 2009 at 9:44am

Quickest way is to use the 'Evaluate Length' for the curve and set the t parameter to 0 - this will show the start of the curve and ultimately the direction of the curve.

Permalink Reply by Arthur Mamou-Mani on July 20, 2009 at 9:51am

thanks a lot Dirk,
Could you then change the direction of a curve if wrong?

Permalink Reply by Arthur Mamou-Mani on July 20, 2009 at 9:58am

i got my answer: flip ;)