Grasshopper

algorithmic modeling for Rhino

simple question and small trick

Hi

i have two surfaces wich are  two facades, when i use divide domain, both are divided in 3 horiontical long surfaces

  Using surface area with output centrum and plug in pointdisplay, one surface shows order 0-1-2

the other show order 2-1-0

so one surface have 0 at the top , the other have 0 at the ground, how do i swip one of the surface upside down,.???? so the area show same order from ground to roof in the point lists.

Now one have 0 at ground the other have 2 .

    Thank you,

Elisabeth              

Views: 293

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on January 6, 2016 at 1:37pm

Hi.

I guess you should flip one surface's V-direction. Demo attached.(LunchBox plug-in needed)

Permalink Reply by Hyungsoo Kim on January 6, 2016 at 1:46pm

Demo..

Attachments:
Permalink Reply by Elisabeth on January 6, 2016 at 2:24pm

Hi

Thanks a lot...I did not try the lunchbox reverse surface direction, i try cool...............

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service