algorithmic modeling for Rhino
Hi,
I believe I run in to a simple problem, but one iI can't seem to figure out.
I am trying to create ribs from a surface and then orient them for lasercutting.
But even while i created planes for each rib it projects every rib on every single plane...
somebody got a golden tip for me?
Tags:
Try "Graft"-RMB over orient's B(Target Plane) input and choose Graft.
Thank you so much!! I tried for 2 hours sigh
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by