short list, cross reference, and long list

Replies to This Discussion

Permalink Reply by David Rutten on April 10, 2013 at 6:45am

See attached. If you want to cross-reference more than two parameters, zoom in on the Cross Reference component and add more inputs.

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Attachments:

• crossreference.gh, 11 KB

Permalink Reply by bobro on April 10, 2013 at 7:17am

Hi David... it's don't work and I don't understand the logic...

Attachments:

• TOW REV 001.gh, 12 KB

Permalink Reply by Michael Pryor on April 10, 2013 at 8:35am

the inputs are the things you want to cross reference against each other. Then you use the outputs to plug in to the next components. 

Permalink Reply by David Rutten on April 10, 2013 at 8:42am

You have three curves in three separate parameters. In other words you have three lists of one curve each. There's nothing to cross reference. 

If you want to loft them all then just put all three wires into the same input. This incidentally doesn't work, the loft somehow fails.

I can loft each pair of curves though:

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by bobro on April 10, 2013 at 12:42pm

ok that's is good...in any way if you know any tutorial around these new components...?!